- 277
- 0
zits and bubbles on large layers(lemmy.world)
I’m printing some trays that are thin on the bottom maybe 2mm. Not enough for there to be infill. I’m having the same issue on two completely different printers with different filament and different files. I’m using the same Orca profile for both of them though so it has to be a setting, maybe bed…
- 0
I fixed my first layer issue with a new z axis motor.(lemmy.world)
Shortly after I posted about my weird first layer issue the z axis motor failed completely. It is an oddball cheap motor and I could not find a direct replacement. The screw was also a very small diameter piece of all thread. I replaced the motor with a standard nema motor with a printed bracket. I…
- 0
Got this bad boy running again(lemmy.world)
This is a clone of an original MakerBot Replicator with dual extruders, yes it’s made out of wood. I’ve had it for about 12 years and tinkered with it a lot. I started having problems with it and it got set aside for bigger and better printers. I got bored and decided to bring it out again. The…
- 0
Weird first layer issue.(lemmy.world)
I have an old Monoprice Select Mini Pro (v3) that has sat for years. I got it out today to see if it still works and it does. It printed fine the last time I used it but I’ve gotten bigger and better printers since then. However I lost the slicer profile I was using and decided to start from…
- 0
!dullsters@dullsters.net has been created.
The community voted on Wjrii@lemmy.world suggestion of !dullsters@dullsters.net The current community here on world will stay open. I have no plans of shutting it down unless the community decides it should. Thank you all again for creating such a wondetful place,I look forward to seeing the…
- 0
I created a Lemmy instance and the future of this community.
I’ve created a new Lemmy instance at dullsters.net When I created this community several months ago I had no aspirations of it becoming much of anything. In a short amount of time it has grown to over 1500 subscribers and is one of the top recommended non-political communities. I am always looking…